![GD&T Datums, Reference Frames, & Part Immobilization | 3-2-1, 4-1-1, 4-2-0 | Actual Mating Envelopes - YouTube GD&T Datums, Reference Frames, & Part Immobilization | 3-2-1, 4-1-1, 4-2-0 | Actual Mating Envelopes - YouTube](https://i.ytimg.com/vi/ZN1LWcIURJI/maxresdefault.jpg)
GD&T Datums, Reference Frames, & Part Immobilization | 3-2-1, 4-1-1, 4-2-0 | Actual Mating Envelopes - YouTube
![Is it acceptable if I create a datum feature and do not refer it anywhere in the drawing? - Drafting Standards, GD&T & Tolerance Analysis - Eng-Tips Is it acceptable if I create a datum feature and do not refer it anywhere in the drawing? - Drafting Standards, GD&T & Tolerance Analysis - Eng-Tips](https://res.cloudinary.com/engineering-com/image/upload/v1527770906/tips/datums_defined_sgewm9.png)
Is it acceptable if I create a datum feature and do not refer it anywhere in the drawing? - Drafting Standards, GD&T & Tolerance Analysis - Eng-Tips
![GD&T Tip - Watch the Placement of Datum Identification Symbols and the Feature Control Frames for Straightness, Perpendicularity, Parallelism and Angularity - 1994 & 2018 GD&T Tip - Watch the Placement of Datum Identification Symbols and the Feature Control Frames for Straightness, Perpendicularity, Parallelism and Angularity - 1994 & 2018](https://www.tec-ease.com/tipimages/aug-98.png)
GD&T Tip - Watch the Placement of Datum Identification Symbols and the Feature Control Frames for Straightness, Perpendicularity, Parallelism and Angularity - 1994 & 2018
![Position Tolerance - Flat datum, and two circular datums.. What is this control frame saying ? - Drafting Standards, GD&T & Tolerance Analysis - Eng-Tips Position Tolerance - Flat datum, and two circular datums.. What is this control frame saying ? - Drafting Standards, GD&T & Tolerance Analysis - Eng-Tips](https://res.cloudinary.com/engineering-com/image/upload/v1657854486/tips/pos_tol_2_jmbhr9.jpg)